BrewForge Docs

Connect a Tilt hydrometer

Connect one or several Tilt hydrometers to BrewForge through TiltBridge or TiltPi, with each Tilt color as its own device.

The Tilt sends its readings over Bluetooth, so it needs a bridge that forwards them to the internet: TiltBridge (an ESP32 device) or TiltPi (a Raspberry Pi app). Both can post to a custom URL, which is how they talk to BrewForge.

One Tilt

In BrewForge, add a device of type Tilt Hydrometer and copy its webhook URL.

Open your TiltBridge or TiltPi settings and add a custom URL webhook.

Paste the BrewForge webhook URL and save.

Several Tilts: Tilt Bridge

If one bridge forwards several Tilts, use the Tilt Bridge device type instead:

Add a device of type Tilt Bridge and paste its URL into your TiltBridge or TiltPi, as above.

Wait for the first readings. BrewForge creates one device per Tilt color automatically, named after the color, for example Tilt Black or Tilt Green. Until then the bridge's section on the Devices page says Tilts appear here once the bridge sends them. Once they arrive, they are listed in the bridge's section and on the bridge's own page.

Open each Tilt and connect it to its own brew. The bridge itself can't be connected.

What BrewForge reads

FieldUsed as
color (or Color)Which Tilt sent the reading (Tilt Bridge).
gravity (or SG)Gravity in SG.
temperature (or Temp)Temperature. Treated as Fahrenheit unless temp_units is C, because Tilts report °F.
battery, rssiBattery and signal strength, if sent.

Temperatures far too low?

If your bridge already converts to Celsius but doesn't send temp_units: "C", BrewForge reads 20 °C as 20 °F (−6.7 °C). Set the bridge to report Fahrenheit, or make it include the unit.

Tilts are calibrated in TiltBridge/TiltPi. For a constant error, a gravity offset in BrewForge is the quickest fix.

On this page