Connect an iSpindel
Send iSpindel gravity and temperature readings to BrewForge over HTTPS, step by step, including Plato and Fahrenheit handling.
The iSpindel is a DIY WiFi hydrometer that measures its tilt angle and turns it into gravity. It can push every reading to BrewForge over HTTP.
Setup
In BrewForge, add a device of type iSpindel and copy its webhook URL.
Put the iSpindel into configuration mode (press its reset button, or take it out of the fermenter and lay it flat) and connect to its WiFi access point. Its configuration portal opens.
Under Configuration, set:
| Setting | Value |
|---|---|
| Service Type | HTTP |
| Server Address | brewforge.sh |
| Server Port | 443 |
| Path / URI | your webhook URL, including ?key=… |
Save. The iSpindel restarts and sends its first reading after the configured update interval. In BrewForge, the device page switches from Waiting for the first reading to Online · ….
What BrewForge reads
BrewForge reads these fields from the iSpindel's JSON:
| Field | Used as |
|---|---|
gravity | Gravity. Converted from Plato when gravity-unit (or gravity_unit) is P. |
temperature | Temperature. Converted from Fahrenheit when temp_units is F. |
angle | Tilt angle (shown in the data log). |
battery | Battery voltage. |
RSSI | WiFi signal strength. |
The gravity comes from the polynomial in your iSpindel's calibration. If readings are off by a constant amount, set a gravity offset in BrewForge; if they are off by different amounts at different gravities, recalibrate the iSpindel itself.
Update interval
BrewForge logs at most one reading every 14 minutes per device. An interval of 15 minutes or more is a good balance between detail and battery life.